82L/2261 Marking Ink Black, 1 Quart

Adherence: Adherence qualities are good on clean, bare metals of all kinds, glass,most plastics, and rubber compounds with the exception of silicone. Prior to testing adherence we recommend an air dry period of 24 hours. An application of heat (when the surface temperature reaches 250°F) for 30-45 minutes will give even better adherence and greater solvent resistance.

Resistance:  82L/2261 is resistant to water, salt spray, gasoline,lubrication oils, alipathics, hydrocarbons, many alkaline and detergent compounds, as well as to some degreasing solvents. Limited exposure to temperatures up to 350°F does not appreciably affect adherence

Corrosion: Since this ink contains phenol (acid) it may tend to corrode some metals.  It is suggested that a thorough check be made before putting this ink into production.

Drying Time: Room temperature, humidity, and ink film thickness all may cause a great difference in drying rate. On the average however, the ink, when applied with a rubber stamp and pad, will dry to touch in approximately 6 minutes.